Education
|
|
Special Offers
|
Service & Updates
|
Helpful Information
|
Store Information
|
|
Please keep watching this page!
We have just started the "Great Scott" articles, where you will find many tips and tricks to keep your machine in tip-top shape!
Why do we call it "Great Scott?" Because it just happens that two of our most experienced technicians are named Scott; and we think they are pretty great. You will too as you read what they are going to share with you.
|
| Tip #1 With all the computerized machines out there today, you need to have a good surge suppressor. A surge suppressor is a plug or set of plugs with a breaker built in. That breaker detects when a surge of voltage comes through the lines and trips the unit off to protect anything plugged in. Of course it is always best to unplug your machines when they are not in use, because even the best surge suppressors fail! |
| Tip #2 If your machine starts making an unusual noise or is laboring, you should immediately stop sewing/serging and check it out. Often, if you continue to sew you will damage a part or parts inside and it can be a costly repair! Take a look at the usual culprits—the take-up lever, the needle, the threading path, etc… If you still have not solved the problem, call us and describe the noise—better yet, hold the phone to your machine so we can hear it. We can tell you if you should bring it in for service. |
| Tip #3 Needles come in many different types and sizes for a reason. To get the best result you need the right needle for the job! If you are'nt sure about the variety of needles on the market, you might want to buy a needle chart to help you. When using a specialty needle, write down what needle you are using on a small piece of paper or sticky note and stick it to your machine or needle pack. When you are done with it, write on that paper how many hours you used it and stick the needle through the paper. Needles are only good for about 4 to 8 hours! After that they dull, bend, or develop burrs, which can not only damage your project but could damage your presser foot or machine. The cost of a new needle is far less than a ruined project or a service call. |
|
|
Home